Ubuntu 11.10: Unity Desktop Poll

Ubuntu 11.10 getting wireless BCM4311 working

I have an HP laptop model nx6325 with a Broadcom BCM4311 wireless card.  After installing Ubuntu 11.10, I find that my wireless doesn’t work.  The reason, Ubuntu detects the wireless but then loads the incorrect driver for this card.

I use the lspci command to display the details about my hardware. It will display all of your PCI connected hardware. I edited the output to show only the relevant information.  The important information here for  matching your hardware with mine is this indentifier [14e4:4312].

$ sudo lspci -v

30:00.0 Network controller: Broadcom Corporation BCM4311 802.11a/b/g (rev 01)
        Subsystem: Hewlett-Packard Company Broadcom 802.11a/b/g WLAN
        Flags: bus master, fast devsel, latency 0, IRQ 18
        Memory at c8000000 (32-bit, non-prefetchable) [size=16K]
        Capabilities: [40] Power Management version 2
        Capabilities: [58] MSI: Enable- Count=1/1 Maskable- 64bit-
        Capabilities: [d0] Express Legacy Endpoint, MSI 00
        Capabilities: [100] Advanced Error Reporting
        Capabilities: [13c] Virtual Channel
        Kernel driver in use: b43-pci-bridge
        Kernel modules: ssb

$ sudo lspci -nn
30:00.0 Network controller [0280]: Broadcom Corporation BCM4311 802.11a/b/g [14e4:4312] (rev 01)

The Solution

I am  going to install the correct driver for this wireless card. Then I will remove the “incorrect” driver (bcmwl) which Ubuntu installed by default.

$ sudo apt-get update
$ sudo apt-get install firmware-b43-installer
$ sudo apt-get remove bcmwl-kernel-source
$ sudo reboot

Hopefully you found this useful.

If you have this same type of wireless chip in your laptop, these instructions might also work for you.